Hangers / Installation
- Unistrut Clamp
Cut Installation Times dramatically on Industrial Ductwork Systems when using these Clamps with Unistrut channel.
- Duct Pipe Hanger HJ
The Duct Pipe Hanger HJ provides a very sturdy connection that does not allow the pipe to move in any direction. The Pipe hangers from 3 to 24" in diameter come in either 14ga Galvanize metal or 16ga SS. The Clearance hole is 7/16th. Bolts and nuts are supplied with hanger.
- Duct Pipe Hanger
The QF Duct Pipe Hanger provides a very sturdy connection that does not allow the pipe to move in any direction. The Pipe Hangers from 3 to 24 inches in diameter come in either 14ga Galvanize metal or 16ga SS. Hangers over 24” in diameter are manufactured from 3/16” flat barred metal. The clearance hole is 5/16th. Bolts and nuts are supplied with hanger.
- Gripple Hanger
The Gripple Hanger is a quick and labor reducing way to hang QF Ducting. The Gripple Hangers come in 15 ft. lengths with 5 options that will hold up to 715 lbs.
- Clamping Duct Hanger
QF Clamp Hangers are manufactured in 14ga galv and 16ga SS from 3 to 24”. Tested by MET Laboratories to hold, without failure, up to 170 lbs for 9” and up to 850 lbs for 20″.
- Roof Flashing
Roof Flashing provides weather protection for Roof penetration. Roof Flashing made in two halves and caulked. For roofs that are not flat there is a maximum slope of 20°.
- Wall Flashing
Wall Flashing provides weather protection (outdoors) and cover (indoors) for wall penetration. One Wall Flashing provides you with both 1 inside and 1 outside flashing (4 halves). They can be ordered with Raw Collar, with or without lip.
- Roof Skirt
Roof Skirt provides weather protection for Roof penetration. For roofs that are not flat there is a maximum slope of 20°. All slope angles of skirt are approximately 27°.